Caronlab Browvado Sculpting Gel Wax Beads 500g 2WBVB5/00870

Caronlab Browvado Sculpting Gel Wax Beads 500g 2WBVB5/00870

Browvado Gel Wax is more than just easy on the eye, this sculpting Facial Gel Wax has been formulated to deliver flawless brows without the post-Waxing redness and irritation.

Browvado has an ultra-fine holographic shimmer when melted but applies semitransparent to ensure optimal visibility. Browvado provides you with the ultimate control to sculpt and contour brows with ease. This hybrid Gel Wax removes even the finest hairs in one application. Ideal for Brow Specialists, Eyebrow Technicians and Brow Artists.

Characterstics

• Semitransparent holographic shimmer with a Honeysuckle and Pear scent
• Rosin Free
• Hypoallergenic
• Vegan Friendly

Benefits

• Low working temperature is gentle on the skin
• Removes fine vellus hairs
• Gel consistency provides unsurpassed control

Usage Instructions – Gel Wax

• Area to be Waxed must be clean, dry and free from any oils and creams. Caronlab Australia recommends the use of Prep – Pre Wax Skin Cleanser as it has been designed to work together for best results with Caronlab Australia Waxes. Always test Wax on the inside of your wrist before use. Do not apply on warts, moles and broken or irritated skin.
• You may begin by dipping Spatula into Wax, which should be the consistency of thick gel.
• Apply Wax with the hair growth using a Browvado Brow Contouring Stick, leaving one edge thicker to create a lip. Gel Wax should be applied in small, thick sections.
• Hold skin taut and remove Wax by pulling in the opposite direction of hair growth.
• For the perfect finish and to remove any Wax residue on the skin, we recommend you use After – After Waxing Oil and Soothe Mango & Witch Hazel or Tea Tree After Wax Soothing Lotion to complete your treatment. To clean equipment use Solvent – Wax Remover Citrus Clean.

Important

• Store in a cool, dry place.

Warning

This is a professional product for Salon use only. Patch test before use. If skin irritation occurs, cease use. Exceeding the recommended instructions may cause burns and/or injury.

Heating Instructions – Beads

• Place Wax Beads into the Caronlab Australia Professional Wax Heater Insert, no higher than ¾ full.
• Heat on the highest setting for 20 minutes. DO NOT stir during this time.
• When Wax is completely melted, turn down to 60°C (140°F) or between dial 3-4 on a Caronlab Australia Professional Wax Heater.
• Dip Spatula into the Wax which should be the consistency of thick honey, if it’s dripping it is too hot.
• DO NOT block the edges of the Professional Wax Heater Insert when topping up Beads. NO MORE than a scoop at a time.
• Always work from a ¾ full Wax Heater.